Do you have a question? Please write us at This e-mail address is being protected from spam bots, you need JavaScript enabled to view it

Q: Which modulation should I use for the transmitter?

A: For the beginning we recommend using PPM.

Q: Why does the receiver not want to bind on setup or when changing the receiver?  

A: If the transmitter and receiver are too close (within two feet distance), the exchanging signals will be too strong, causing the receiver to either not accept the signal or go into a reset. The same can happen when testing the system with the transmitter being too close to the receiver. The log file will record Radio disconnected and Radio connected in short  time sequence with no failsafe frames reported.

Q: Which antenna of the Micro receiver is used for the downlink back to the Transmitter?

A: The antenna right next to the jumper hole is the receiver antenna that does the transmission for the downlink of the Micro receivers.